Repairing Cracked Seams in Painted Wood Cabinet Doors

Older wooden cabinets, especially the doors, regularly hint at wear as dents, scratches or breaks. A split surface may be disappointing to the eye, yet it can likewise bring about further damage. A break can permit dampness to enter the door, causing more breaks and conceivably augmenting existing ones. In extreme cases, dampness can additionally twist the doors. It is consequently that you may as well repair the doors when splits begin to improve. Despite the fact that filling the splits might take just a couple of minutes, it is painting the door that sits down for a bit.

  1. Remove the damaged door from the cabinet by evacuating the screws that protected the door pivots to the cabinets with a screwdriver. Assuming that the door pivots are held in place with a vertical pin, drive the pin upward with a screwdriver and a mallet.
  2. Position the door on an even surface.
  3. Wash the front of the cabinet with a gentle cleanser, then climb the cleanser off the door with clean water and a wipe.
  4. Scrape away any detached paint encompassing the splits with a putty knife.
  5. Fill the breaks with a latex wood patch item using the putty knife as an utensil. Spread the patch item over the surface while pressing the material into the door. Scrape the abundance material off the door with the putty knife soon after the material dries.
  6. Permit the wood fix material to dry.
  7. Sand the whole surface of the door with fine-grade sandpaper. It is not indispensible to remove the existing paint. The reason here is to rough the surface slightly to give new paint something to hold fast to.
  8. Wipe down the cabinet with a tack cloth to remove the sanding buildup.
  9. Apply a quick drying oil-based preparation over the patch zone with a paintbrush. It is not fundamental to take action divides of the door.
  10. Paint the door with a 2-inch trim brush. Paint the focal point area of a door with recessed panels before painting the flat tails and vertical stiles.
  11. Permit the paint to dry, then apply a second layer of paint if vital. Assuming that applying a second cover, sand the first layer slightly to rough its surface, then wipe the door down with the tack fabric before painting.
  12. Apply a solitary layer of clear wood sealer over any unpainted surfaces of the door with the paintbrush to forestall dampness from entering the wood.

Related Post