How to Make Solid Wood Cabinet Doors

Solid wood cabinet doors are standard in high-end homes. Frequently the door is molded with a raised panel. Generally have favor tracking on their edge, however they all begin the same, as an aggregation of sheets laminated together. Raised panel doors require machines that generally individuals don’t have in their garage, and take specialists to assemble. However you can manufacture your own solid wood doors at home using just a table saw and a few braces. The piece outline has been around for a long time and looks incredible.

  1. Build a door for an opening that is 16-by-20 inches. The standard is to add 1 ½ creeps to the width and stature of the door opening- -thus the door size will be 17 ½ by 21 ½ inches.
  2. Cut the hardwood wood into 2-inch boards. Crosscut the boards at 24 inches. Straighten every one of them over two sawhorses, side by side until the width surpasses approximately 18 inches.
  3. Examine every last one of them and place any deformities -breaks or discolored imprints -confront down. Grab each second board and swap closes with it to arrange the grain design in inverse bearings. This is to avert part as well as distorting of the door.
  4. Stand the barricades on their edges. Run a dot of glue along the edge of every last one of sheets aside from one on the outside. Lay all the sheets together with the goal that one of the glue edges reaches the dry edge of an alternate board. Flush the finishes of every last one of sheets to one another.
  5. Reach over the center of the piece with a bar clip and place it on the chunk, tightening it slightly. Arrive at under on every closure and place a bar clasp on every finish.
  6. Using a mallet, pound all the sheets flush with one another. Tighten the clasps until glue overflows out of each split. Let dry for 60 minutes.
  7. Scrape off the dry glue and slice the door to 17 1/2-by-21 1/2 inches. Sand the whole door with a sash sander. Track a decorative edge on the door if craved. Finish by sanding the door with an orbital hand sander with 100-grit sandpaper.

Related Post